Course Details

Previous Page


SIMOS 1.0: Deploying Secure Site-to-Site Connectivity Solutions (Part 1)


Overview/Description
Target Audience
Prerequisites
Expected Duration
Lesson Objectives
Course Number



Overview/Description
Point-to-point is the simplest VPN topology and it constitutes two networks communicating over an encrypted connection. In this course, you'll learn about the steps to configure point-to-point VPNs on Cisco ASA hardware. This course is one of a series in the Skillsoft learning path that prepares the learner for Cisco certification exam 300-209 SIMOS. This exam counts toward CCNP Security certification.

Target Audience
Network security engineers and learners preparing for Cisco CCNP Security certification

Prerequisites
None

Expected Duration (hours)
1.8

Lesson Objectives

SIMOS 1.0: Deploying Secure Site-to-Site Connectivity Solutions (Part 1)

  • start the course
  • describe hub and spoke and full mesh site-to-site VPN topologies and hybrids
  • list services for site-to-site VPNs
  • describe VPNs using encapsulating security payload and internet key exchange
  • describe the internet key exchange process and the differences between IKE v1 and IKE v2
  • describe the encapsulating security payload protocol used in IPSec VPNs
  • describe virtual tunnel interface to configure IPSec-based VPNs between sites
  • describe dynamic multipoint VPNs to route IPSec traffic
  • describe how FlexVPN can reduce complexity when deploying VPNs over different transport networks
  • describe requirements for configuring point-to-point IPSec VPNs on the Cisco Adaptive Security Appliance
  • describe the configuration process for configuring point-to-point IPSec VPN tunnels on the Cisco Adaptive Security Appliance
  • enable IKE on a Cisco Adaptive Security Appliance interface
  • start the configuration wizard for configuring point-to-point tunnels on Cisco Adaptive Security Appliance
  • configure IKE policy for point-to-point tunnels on Cisco Adaptive Security Appliance
  • configure tunnel groups for point-to-point tunnels on Cisco Adaptive Security Appliance
  • configure crypto maps and transport mode for point-to-point tunnels on Cisco Adaptive Security Appliance
  • configure NAT traversal and IKE negotiation mode for point-to-point tunnels on Cisco Adaptive Security Appliance
  • configure point-to-point tunnels on Cisco Adaptive Security Appliance using connection profiles
  • verify point-to-point tunnels on Cisco Adaptive Security Appliance using connection profiles
  • troubleshoot point-to-point tunnels on Cisco Adaptive Security Appliance using connection profiles
  • configure a point-to-point VPN on Cisco Adaptive Security Appliance
  • Course Number:
    cc_smos_a02_it_enus