Course Details

Previous Page


Cisco SWITCH 2.0: Inter-VLAN Routing


Overview/Description
Target Audience
Prerequisites
Expected Duration
Lesson Objectives
Course Number



Overview/Description
To transport packets among VLANs, you need a Layer 3 device. This device can be either a router or a switch with Layer 3 capabilities. Inter-VLAN routing can be performed by an external router that uses a separate link for each VLAN. Because the number of physical connections on a switch is limited, this solution is not scalable. A better solution is to have a single trunk link, between the router and the switch, that carries data for all VLANs. This setup is commonly called a router on a stick or a one-armed router. A convenient solution is to have a device, such as a multilayer switch, that combines switching and routing functions into one device. In that case, no external router is needed. In this course, you’ll learn how to configure an external router for inter-VLAN routing and learn the steps the configure routing on a multilayer switch. This course offers the official training for the Implementing Cisco IP Switched Networks 2.0 certification exam which is a component exam for the CCNP and CCDP certifications. Passing this exam will also refresh CCNA certification, which expires after three years.

Target Audience
This course is intended for students who are looking for real-world switching knowledge, and those that are considering CCNP and CCDP certification. This course’s discussion of switching could also benefit early CCIE Routing and Switching candidates.

Prerequisites
None

Expected Duration (hours)
1.6

Lesson Objectives

Cisco SWITCH 2.0: Inter-VLAN Routing

  • start the course
  • explain the function of inter-VLAN routing with an external router
  • configure inter-VLAN routing with an external router and verify its operation
  • configure inter-VLAN routing with an external router and verify its operation
  • describe the advantages and disadvantages of configuring inter-VLAN routing with an external router
  • describe the SVI
  • configure SVI on a switch
  • provide an example of configuring a routed port on a switch
  • configure SVI with the autostate exclude command
  • describe the role of a routed port on a switch
  • recognize the steps involved with the configuration of a routed interface
  • identify the checklist of SVI configuration
  • use EIGRP to advertise the subnet of a VLAN
  • configure the EIGRP network statement
  • provide an example of Switch Block routing
  • compare Layer 2 and Layer 3 EtherChannel
  • configure Layer 3 EtherChannel
  • configure Inter-VLAN routing
  • Course Number:
    cc_swch_a06_it_enus